Download Scaps Driver
CBUSB Ver 2.0 (if you have a SCAPS USB Dongle connected) Figure 28: Windows Device Manager (English) Please find information on how to update the USB Driver in the corresponding chapter.
Download Scraps Drivers License
- Hardware drivers category page Microsoft Download Center Microsoft 365 Premium Office apps, extra cloud storage, advanced security, and more—all in one convenient subscription.
- » scaps mechani » scaps download » scaps samlight » download scaps » scaps samlight ソフトウェア » scaps video ocx deph 24 color » scaps sam light software all versions » scaps sam light download » scaps 3.7.5 download » scaps software laser.
- Update the device driver. In the search box on the taskbar, enter device manager, then select Device Manager. Select a category to see names of devices, then right-click (or press and hold) the one you’d like to update. Select Search automatically for updated driver software. Select Update Driver.
- ASUS Download Center Download the latest drivers, software, firmware and user manuals. Please enter a model name. How to find Model Name; Or Select a product.
ChromeDriver
|
For installing the SCAPS hardware please connect the hardware with the PC as described in the following points:
Connection USC with a PC:
The connection between the USC card and the PC can be done by USB or by ethernet (except USC-1). Please make sure that that the USB cable is as short as possible to avoid connection problems. After connecting the hardware to the PC it may durate some time until the drivers were automatically installed. If you are not sure, if all drivers have been installed correctly you can check it in the windows device manager. If you are using an USC card, there should be a folder Jungo Connectivity and SCAPS USC: USB Scanner Controller. If you are using an USB-Dongle, then it should be located at USB controllers→ CBUSC 2.0.
Read the information in this chapter very careful. Wrong power supply or inappropriate components could result in hardware damage! |
The USC will be delivered without housing, all relevant safety regulations for integration and operation have to be complied. Mounting the scanner controller in an small housing will require an extra air ventilation to avoid a critical increase of temperature. |
Power supply:
It's highly recommended to supply the USC board via an external power supply. By default, the jumper for bus powered mode is closed for first tests and evaluation purpose. This jumper (USC-1 and USC-2 only) has to be removed before an external power supply is connected. Please verify to connect the USC board to the external power supply before the voltage is applied.
Download Scraps Drivers
Installing an SCAPS USB dongle:
Plug in the USB-dongle at the USB connector of the PC (not necessary if there is an USC-1, USC-2 or USC-3 scanner card installed).
Installing scanner driver cards from a third party manufacturer:
Install scanner driver board and the software drivers as described in the manufacturer's manual. Copy the correction file and the driver files (*.dll) in a separate folder of the hard disk.
If using a RTC card there should be an entry RTC... in the entry SCANLAB.
Download Scraps Driver Download
Scan head:
As a general rule, only shielded data cables should be used to connect a scan head to the scanner controller. It's elemental that the cable shield is aligned to electric shield of the scanner controller. To avoid electrical damage to the scan head or scanner controller, ensure that all components are currentless during every connection and disconnection. The potential difference between the mass potentials of the scanner controller and scan head should not exceed ±7 V.
The solders jumpers on the bottom can be used to connect the cable shield to the USC GND. It's strongly recommended to connect the USC GND with the cable shield of the scanner. |